The Streamliner

Rat Rod Bikes Bicycle Forum

Help Support Rat Rod Bikes Bicycle Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
So I'm leaving the front wheel for the moment.
On to the main body....
DSC_0418.JPG

DSC_0419.JPG

DSC_0421.JPG


I'm doing it in sections to make it manageable
 
So with the shape put in, the front edge is prepared to be turned. I want this as a sharp edge, probably the only one on the bike.
First the fold line is drawn, then the edge is pre-stretched.
DSC_0424.JPG

Then folded and offered up to the bike.
Oops, I put the line in the wrong place!
DSC_0426.JPG

So a new line is drawn using the front axel as the centre of the arc (how I should have done it in the first place!)
And the edge flattened out and re-folded. During this process the edge goes into a horrid wobbly mess.... Stay strong David , it will be fine.... Lol
DSC_0429.JPG
 
Moving on to the drive side, the panel was duplicated, just the opposite.
I want the chain to be enclosed within the bodywork. Unfortunately the pedal hits the aluminium
DSC_0475.JPG

A small step was put in using the swaging machine.
DSC_0477.JPG

It's better, but it still touches the aluminium.
DSC_0479.JPG

So the next step is to flatten out the curvature of the panel. The front folded edge will need stretching and the area within the pedal will need shrinking.
 

Latest posts

Back
Top