It's Bobbcycle time!

[Adapt]

Shoot if anything goes I'm building a frame for my 2 stroke motor........

I started out put my motor on a beach cruiser frame...

Then I started modifying the frame and swapping parts...
But I quickly got bored with it and decided I wanted it to be low and stretched..................

So I drew it our and started bending tubing...

Didn't know how to add the motor......had to order a longer chain too...

Now we're gettin somewhere....

Cut me some custom drop outs and I'm off

I don't have a jig so I have to use the back wheel to keep the back forks lined up...

I thing I got it...

That was hard to fit the top tubes together on this one...

But I like the way the bike is going to sit...

[sensor]

welcome back and looking forward too seeing this one

[Adapt]

Thanks man...

[thesuicideride]

thats a nice lookin custom frame ! looks all big and beefy. bet this one will turn out really cool.

[Gdcast]

Ohhhh, I really, really like this one! I mean I really like it.
Those custom dropouts are awesome, and the curves it has, beautiful!

One thing thou, please tell me you are not keeping that tank!!
Wouldn't you mind if I throw my two cents in?
Looking at the frame, I think it could fit a wider horizontal tube as a fuel container, maybe shaped in the outside with fiber glass or metal sheets...

Please, don't think I´m underestimating your building skills, for what I´ve seen you probably can build your own tank, I now I cant, so I just threw in what seems easy to replace the stock tank with.
Keep up the good work!
Did I mentioned I really like this one?

[UncleKudzu]

looking good!

nice to see a motorized in the mix. i've been trying to come up with something like a slightly stretched frame that would have the engine behind the seatpost, closer to the rear wheel and out of the way. i'll be curious to see how you place the engine.

[rnchoppers]

that is going to be a pretty nice bike ..you know what i did on a few bikes i made with with them motor kits use a fatter top tube cap both ends drill and weld a nut were you want the petcock to be and do the same for the fill cap and use ur top tube for the tank . it will look good no matter what tank is on it

[Adapt]

I got it painted...rattle can....
Not sure on the tank yet...I was planning in pin stripping it...

[Gdcast]

Looking good!!
Closeup on the seat please? It´s a keeper...

[AussieJester]

Frame looks superb not sure on the crank position? Knees up under your chin when pedalling by the look....not that you will be doing alot of pedalling i guess...

KiM

[Adapt]

Yah you're sort of right...the peddles were too far back...
I'm gonna move them forward about 3 inches...

[AussieJester]

Yah you're sort of right...the peddles were too far back...
I'm gonna move them forward about 3 inches...

If it was mine i would be looking to place it round about here--



Anywhere on the tube it is now though will give you a high knee level when crank is in the upward position, i have similar issues with my current project, i actually attached the bottom bracket yesterday also.

Best of luck

KiM

[Adapt]

Yes but that is where the motor will sit....
It worked out alright...
I'm finishing up putting it together...
pictures are coming soon...

[Adapt]

Practiced my stripping on the tank...it's OK


Didn't have a Mooneyes Sticker so I had to paint on a fake one...

[Kuttnhack]

Great finished product. You, without a doubt nailed the look.