Recent content by Dynomight!

The brake conversion I got from amazon for about 60 bucks. The kit came with the leaver, rotor, caliper, rotor axle mount, and cable. The trike rear end I have is older, so there is no factory caliper mount on the frame. Also if you go with this kit, the caliper is really cheap, I replaced it...

I've been working on this for a while now. Tried to get it together by the build off but couldn't get it done, so now I'm taking my time with it. Dyno-glide with an older Miami sun trike rear end.

Found out that Sun makes an axle rotor adapter, but they don't sell just the adapter. So the kit is on order all for ONE PART, but I won't have a wobbly rotor!!! Unfortunately this sets me back on basically everything else since I can't mount the bracket or start on the bed till get the rotor...

Brake finally showed up. Gotta fab a mount for the rotor, the caliper mount is basically done. I have to weld it on but I can't do that till the rotor is set. This is the basic mock design.

I'll be getting my caliper and rotor later today for a disk setup on the rear axle. I just don't trust this sketchy bent springer to do anything more than turn the bike. heck, even then it has to be adjusted all the time. I've also been thinking of adding a set pin to the spring collar on the...

Today I decided to try and get the bed started with some stuff I had laying around. unfortunately it isn't even close to what I want so I'll actually have to spend some money. :mad:

I wasn't going to get in on this but I can't help myself. I had started a build with this frame but decided to go a different direction, so I hope that counts as a fresh start. This is where I was as of the start of the build. 3 days ago I decided to add the board to the frame Then I finally...

Thanks! I'm thinking the next one will be a CB750FOUR, they're so sexy.

Tons of people ride bikes as their primary transportation in Key West. I try to avoid driving because of all the tourist traffic. The Honda was a hundred dollar bike when we found it. After a lot of bleeding and swearing we got her shining again!

Is there a thread on that yet? I found the competitions section and the ORBO, but is this something different?

@sdframe I wanted one for years and finally got it!:banana:

You're right! Since I started lurking I've already decided my next bike will be an actual custom frame build.

I've been lurking for a while and really dig what you guys have going on here. I picked up a Dyno-Glide a few weeks ago from a guy on craigslist and finally started my long awaited cruiser build. The night I picked it up. and how it sits now. Stoked to see what you're all riding and...