Yeah.
I'm thinking I could hide the clamp within the design of the yoke.
I was originally thinking of steel for yokes but am going to have to make them out of aluminium due to thickness and weight. 10mm thick steel yokes will weigh a tonne
Sent from my CLT-L09 using Tapatalk
Haha diablo. My bad dude lol.
I did first think about rotated but then that would make tube fitting harder so may as well use round and mitre.
My thoughts behind this build were...
I had unlimited box at work to use for free (this has now changed but still like the idea)
I wasn't hugely...
These are the bearings I'm planning on using https://pyramid-parts.com/products/steering-head-bearings-kit-22-1003-SSS903-BR24
Sent from my CLT-L09 using Tapatalk
Yeah the square shape is limiting for sure.
The picture below was my initial idea. But that's not going to suitably clamp square legs. Or is it. The clamping force would only be on two side right?
The benefit of your initial idea is I can use the same design across three potential...
OK so both top and bottom are welded to forks.
I was thinking maybe a solid 30mm aluminium rod going all the way through with tapped hole bottom and top and something like M12 screw both sides
Sent from my CLT-L09 using Tapatalk