The first half of the tank mold is done! So far so good.
Next step will be to create 'dams' for the second half.
It is pressed on with a hydraulic press. Should be enough to just cut a bit of the material from the center/inner surface to loosen it.
Well, one obvious way would be to check, if you can make the hole in the sprocket on the distance of the pin on the crank. If yes, then...
This is a 1998 Western Flyer Cruiser. Another one of my late brother's project bikes. I was with him at the Ann Arbor swap when he...
Looks great :thumbsup:
It has to do with what kind of sites you regularly visit...Matti...:tmi:
I think the fenders are stainless steel on at least some of the Hungarian Schwinn's.
I agree, a black stem would fit better, as the crank and pedals are black too. The alloy block stands out
Starnger posted a new thread.
Just scored this 1980 Heavy Duti for 80 euro from Germany (less then 100$), and paid another 60 for delivery.
As far as...
This one is made by Felt.
Nice, the alu frame! Good start for a cool project!
At least the pictures are not climbing the walls. :giggle:
picked up a red betty this morn,nexus 3 speed,real electra flame tires,lepard seat and grips,i think the red betty is alittle harder 2...
So I got the BB adapter. It's a basically just a sleeve with thread for regular BB's. After hammering out the original cups and putting...
[ATTACH] Put on tubes and tires.
Looks OK: IMO the rims are pretty rough. -even after a drill with wire brush.
Oh well; they will...
Separate names with a comma.