firsty fumble ?

[Helluva]

Durring install of a RAW MOTORS 80cc 2 cycle bicycle engine at point of drive chain install I pulled both Clutch Cover and Drive Sprocket covers off engine and somewhere in between a small cylinder 1" long x 1/8 " wide along with a single ball bearing fell to the floor. OK so where do they belong is what I'm asking ?

 

[gokart25]

on the drive sprocket side, the bearing goes in the hollow shaft, right in the middle of the drive gear, then a cylinder(about 1" long) goes in to hold it in. Put some grease on the bearing.

 

[gokart25]

watch this ... at 1:33 you'll see the cylinder, and the bearing goes in first.

 

[Helluva]

on the drive sprocket side, the bearing goes in the hollow shaft, right in the middle of the drive gear, then a cylinder(about 1" long) goes in to hold it in. Put some grease on the bearing.

yep your spot on right cept I fingered it out myself after a cold beer and alotta geussin' but hey thanks for the know how eH"