Ulu

As it turns out my ground wire had come disconnected from the jack & hit the positive lead, causing the howl. Basically it’s like...

It’s a plan that doesn’t fulfill a real need, but just a little tricycle fantasy. If I get off my duff I’d have a truck, two cars, and a...

I don't believe you need to think about your next build at all! Sounds to me like you have a plan with a purpose!

No, I didn’t break it. I took it apart to clean out the cracks. The neck is stamped 2084, in ink. The body is marked LH, in pencil...

I have little excuse for not building, except that I don’t need a new bike & I should sell some of the old ones. I need to think long...

I think it depends on how old you want the bike to look when it is finished. If you want it to look like it’s from the fat bike era...

Managed to notch the other tubes (almost all) by hand. I cheated in regards to the left loopy: I did not have the tools to hold it...

The last time I welded a bike frame, I torch welded it and then I put brass over the top of that, after cleaning up the steel. but that...

When I was a child, my Schwinn had that same type of seat on it, and I always wondered why it said, “Schwinn approved“? I just couldn’t...

I got some parts in. Cleaned up the cranks and put on the 38 tooth inner ring. I thought I would prefer a bare aluminum chainring to...

A cool care package came from @Captain Awesome . Thank you so much. Such a great person and you do so much for this site. I got...

Correct. Norco (Northern Corporation) was here making tough bikes for Canadians before mountain bikes. 1982 Custom Cruiser: Brodie...

I think that was the one before this one. It was “Les Miserable”

The next thing I did was fabricate a tool box to mount between the seat down tube and rear fender. I had to have a place to stow the...