CRASH's latest activity

Mostly ok. These NOS 20” fenders were mint, now a little bent and scratched up but I think I can salvage them. I don’t think there was...

A true bike guy. He just wanted to let you know that the bike parts were okay. :D

He texted me with the picture of the parts and said he made a mess. He failed to tell me how! I figured he took a turn too fast! He...

I don't have a derailleur alignment tool because I don't really need one. These old hanger derailleurs can be tweaked to work. That's...

It wasn’t before, and all I did was spread it, so I guess I spread it unevenly. How do you suggest I bend then back?

I checked the frame alignment. It’s roughly 1/2” wider on the non drive side. So, keeping the width on the rear drop outs, how do I...

Here’s the freewheel with the thickest spacer. The wheel was having a tough time dropping in, so I had to open up the stays again...

Had these two spacers made. (Bottom) and found a nylon space we had at work, so grabbed a couple just in case. Here’s the back of the...

Good idea with the BMX set up. I wanted to keep the Huffy sprocket, but I'm not married to it. I'll look into that in case the rear...

Have used bmx spider with chainring spacers to get chain line for 9-10-11 speed sting rays.

I'm going to give that a shot first. I'm having some spacers made at work at two different widths to see what happens. I'm also...

For the dish, the hub would have to be pushed to the drive side, the rim to the non drive side. But I don’t see how that wouldn’t still...

I’m brainstorming. I thought I could gain a little clearance, especially with the white letters, if I sand the sharp edge of the...

3/32. Good thought.

When adjusting the shifting I ran into a problem I didn’t realize I’d hit, but makes sense. The fat tire is in the way of the chain...