welding

Rat Rod Bikes Bicycle Forum

Help Support Rat Rod Bikes Bicycle Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. A

    Welding Chromoly Frame With Flux Core

    Hello all, I'm new to bike frame fabrication. I have a Lincoln flux core welder I split with a friend (I'm a college student). I'm wondering if I would have to only use mild steel or if I could use my flux core welder to weld prefabricated chromoly tubes? I've seen some information on the...
  2. C

    Dropout Conversion - What do I need to know?

    Scored some glorious roadkill today (pictures later; it's miserable out). 26x4 fat single-speed MTB. Disc brake ready with only a couple parts missing (rear brake looks perfect, front lever, cable, and hardware other than the disc are MIA). Everything on it still looks to be in the correct...
  3. Ethan

    Rollin' Scrap....

    I recently acquired an older cantilever frame. No brand, no markings, there may be a serial number stamped in the bottom of the frame....or it may be my imagination. It does have a couple issues, the worst of which is the dropouts, 1 side in particular is a wreck. This is the frame as I got it...
  4. Ethan

    DIY sissy bar....almost done

    Am doing a few projects recently, this is one getting closer to done than some others. I used the lowers from a standard seat support and fashioned this out of 1/4 rod I have in the form of something totally unrelated to bikes. All the twists and bends done by hand, with a torch and a few basic...
  5. franconuevo

    You can weld it. ends tomorrow

    Here, take these coupons to your nearest Harbor Freight store, and for just over a Benjamin...you don't have to wait on a buddy, or pay out each time you just need a quick weld. and once you get it down you can chop and weld no prob., Ive built two bikes already with this exact setup, including...
Back
Top