A few months ago I switched home owners insurance companies after the one I had for nearly 20 years tripled its rates. The new company, which I'll leave nameless for now, insisted on an inspection of the premises.
They came out, did the inspection while I was not home. (No clue how they did that accurately), but they found issue with several things and notified me of pending cancelation due to several reasons.
First and foremost was that I have two unility trailers parked in the back yard, second was because I have a commercial diesel pickup truck parked at my residence, (which they insure), and that I have a garage full of bicycles, derelict bicycles, and bicycle parts 'strewn' about the garage and all over multiple 'unsecured' shelves.
I called the agent and was told that my auto policy is not affected but they have dropped my homeowners policy and its not open for review.
The truck is a stock F250, four years old and my personal vehicle with passenger plates.
The two trailers are motorcyle trailer and a 4x8 Snowbear trailer that i bought about 10 years ago. Both registered and tagged. Neither is visible from the road, both are chained to a tree behind the garage.
In the garage, is my car on the right, and the left and rear wall are covered with 8ft tall 2x4ft P slot steel shelving from Lowes. Most of which is tools, and a few dozen blue tubs of bike parts.
I have four bike stands, two on the work bench between the two bays, and a double that stands free in near the rear bench. There are 43 complete bikes in all, some hanging from the ceiling, some parked on roller stands on the floor. There's a rack in the corner with bike frames hung by their rear dropouts, and the wall over the bench is pegboard covered in bike tools. Its been the same for about 25 years or so. A few are packed away in the attic of the house for safe keeping too. There's a pair of Snap On toolboxes between both bays as well and I have a 14x22ft shed out back for storage too, that's prettymuch an extension of the garage with both bikes, a couple of garden tractors, a snow blower and my push mower. Plus some wood working tools.
Immediately asked the agent to find a solution, and the only solution was to go back to my old insurance company at the higher rate. I was dead set against that idea. A week of searching found me a new company with reasonable prices but again they have an issue with the bicycles? My agent brought it to their attention so as not to have another issue like before. After speaking to their representative, it seems they're concern is ownership and liability for the value of each bike. They want me to make a list and state the fair market value of each bike.
I'm fine with that but how does one come up with that?
The bikes are their big concern for some reason.
How would you value the list above?
I honestly never thought much about what they were worth because I have no intention of ever selling any of them.
CL prices are all over, I see minty clean bikes for $25 that don't sell and bikes listed for $500 that don't ever seem to sell here. Its not really a bike area for the most part.
Plus, all it takes a trip to the flea market or auction and there could be a few more added to the list any time and I've got several in the works that I've been hunting parts for too.
None of my bikes are high end, most are English three speeds from the late 50's to early 70's. Plus a few prewar balloon tire bikes, (no tanks, just run of the mill complete bikes in well maintained condition, plus a couple road bikes, again, nothing special but clean old bikes I bought new myself back in the day, plus a few loaner bikes for guests or the girlfriend to use.
To me, I value the Raleigh Sports and similar bikes around $300 each, and likely the same for most of the other bikes give or take $50. Maybe a bit more for the prewar stuff but none of it is 100% original or 'restored'.
I have,
1936 Western Flyer (no tank, no cg, repainted in the 70's)
1941 Elgin curved seat tube, non original frame, bars, and repainted several times with USAF base ID all over it from a NJ air base in the 50's. (A relative brought it home after they tossed it in the dumpster back in the late 50's.
1941 Elgin curved seat tube all apart at the moment.
1949 Columbia Newsboy bike that belonged to my dad many years ago.
1955 Schwinn Hornet, all original, just maintained
1956 Schwinn Traveler Tourist three speed, in nice original shape, estate sale find during a trip to AZ in 1996)
1957 - 1977 various English three speeds, Raleigh, Robin Hood, Dunelt, Hercules, and Crown models all clean and well maintained. 11 in all
1959 Burgers ENR three speed, in nice original shape.
1962 Schwinn Traveler Deluxe 3 speed, (bought while on vacation one year, its been with me for 30 or more years)
1965 Schwinn Racer coaster brake
1968 Carlton Grand Prix, (auction find, a clean old bike in my size)
1969 Jacques Anquatil 10 speed, (similar to a Gitane Interclub that year.)
1970 Peugeot UO-8
1970 Peugeot UO-18 mixte
1971 Schwinn Speedster coaster brake
1972 Raleigh Sprite 27 three speed model
1972 Rollfast Ultralight 26" lw coaster brake
1974 Schwinn Varsity, (had this since 1976, belonged to a cousin who joined the Navy around that time).
1977 Nishiki International 10 speed, (all original, belonged a buddy's dad growing up).
1978 Raleigh Super Grand Prix (minty clean, bought it new old stock myself 18 years ago)
1978 Raleigh Super Course (well used, had it since new, but 100% functionally)
1979 Schwinn Continental II 10 speed
1980 Nishiki Custom Sport 12 speed, (bought it new in 1980 and used it alot back then but not lately)
1980 Ross Grand Tour 10 speed
1985 Raleigh Grand Mesa MTB
1985 Nishiki Pacific Cruiser.
Plus four or five in the process of going together or getting built, plus a dozen or so frames and forks hanging on the wall and a few dozen spare wheels in the rafters and garage attic.
To me, if I look at the '85 Pacific cruiser, which I just completely went through top to bottom, cost around $225 new in 1985 money but even more important, I cannot buy a bike like that brand new today, and anything close would be upwards of $400 or more for a decent shop grade bike. Even then it would likely be just another Chinese made bike.
I have no clue though how to price it today. I realize none are highly 'desireable' models, but they want 'replacement value' on each bike and for the total sum of bikes and parts. What would make 'replacment' of most even harder is that every one of them are taller frame sizes.
They came out, did the inspection while I was not home. (No clue how they did that accurately), but they found issue with several things and notified me of pending cancelation due to several reasons.
First and foremost was that I have two unility trailers parked in the back yard, second was because I have a commercial diesel pickup truck parked at my residence, (which they insure), and that I have a garage full of bicycles, derelict bicycles, and bicycle parts 'strewn' about the garage and all over multiple 'unsecured' shelves.
I called the agent and was told that my auto policy is not affected but they have dropped my homeowners policy and its not open for review.
The truck is a stock F250, four years old and my personal vehicle with passenger plates.
The two trailers are motorcyle trailer and a 4x8 Snowbear trailer that i bought about 10 years ago. Both registered and tagged. Neither is visible from the road, both are chained to a tree behind the garage.
In the garage, is my car on the right, and the left and rear wall are covered with 8ft tall 2x4ft P slot steel shelving from Lowes. Most of which is tools, and a few dozen blue tubs of bike parts.
I have four bike stands, two on the work bench between the two bays, and a double that stands free in near the rear bench. There are 43 complete bikes in all, some hanging from the ceiling, some parked on roller stands on the floor. There's a rack in the corner with bike frames hung by their rear dropouts, and the wall over the bench is pegboard covered in bike tools. Its been the same for about 25 years or so. A few are packed away in the attic of the house for safe keeping too. There's a pair of Snap On toolboxes between both bays as well and I have a 14x22ft shed out back for storage too, that's prettymuch an extension of the garage with both bikes, a couple of garden tractors, a snow blower and my push mower. Plus some wood working tools.
Immediately asked the agent to find a solution, and the only solution was to go back to my old insurance company at the higher rate. I was dead set against that idea. A week of searching found me a new company with reasonable prices but again they have an issue with the bicycles? My agent brought it to their attention so as not to have another issue like before. After speaking to their representative, it seems they're concern is ownership and liability for the value of each bike. They want me to make a list and state the fair market value of each bike.
I'm fine with that but how does one come up with that?
The bikes are their big concern for some reason.
How would you value the list above?
I honestly never thought much about what they were worth because I have no intention of ever selling any of them.
CL prices are all over, I see minty clean bikes for $25 that don't sell and bikes listed for $500 that don't ever seem to sell here. Its not really a bike area for the most part.
Plus, all it takes a trip to the flea market or auction and there could be a few more added to the list any time and I've got several in the works that I've been hunting parts for too.
None of my bikes are high end, most are English three speeds from the late 50's to early 70's. Plus a few prewar balloon tire bikes, (no tanks, just run of the mill complete bikes in well maintained condition, plus a couple road bikes, again, nothing special but clean old bikes I bought new myself back in the day, plus a few loaner bikes for guests or the girlfriend to use.
To me, I value the Raleigh Sports and similar bikes around $300 each, and likely the same for most of the other bikes give or take $50. Maybe a bit more for the prewar stuff but none of it is 100% original or 'restored'.
I have,
1936 Western Flyer (no tank, no cg, repainted in the 70's)
1941 Elgin curved seat tube, non original frame, bars, and repainted several times with USAF base ID all over it from a NJ air base in the 50's. (A relative brought it home after they tossed it in the dumpster back in the late 50's.
1941 Elgin curved seat tube all apart at the moment.
1949 Columbia Newsboy bike that belonged to my dad many years ago.
1955 Schwinn Hornet, all original, just maintained
1956 Schwinn Traveler Tourist three speed, in nice original shape, estate sale find during a trip to AZ in 1996)
1957 - 1977 various English three speeds, Raleigh, Robin Hood, Dunelt, Hercules, and Crown models all clean and well maintained. 11 in all
1959 Burgers ENR three speed, in nice original shape.
1962 Schwinn Traveler Deluxe 3 speed, (bought while on vacation one year, its been with me for 30 or more years)
1965 Schwinn Racer coaster brake
1968 Carlton Grand Prix, (auction find, a clean old bike in my size)
1969 Jacques Anquatil 10 speed, (similar to a Gitane Interclub that year.)
1970 Peugeot UO-8
1970 Peugeot UO-18 mixte
1971 Schwinn Speedster coaster brake
1972 Raleigh Sprite 27 three speed model
1972 Rollfast Ultralight 26" lw coaster brake
1974 Schwinn Varsity, (had this since 1976, belonged to a cousin who joined the Navy around that time).
1977 Nishiki International 10 speed, (all original, belonged a buddy's dad growing up).
1978 Raleigh Super Grand Prix (minty clean, bought it new old stock myself 18 years ago)
1978 Raleigh Super Course (well used, had it since new, but 100% functionally)
1979 Schwinn Continental II 10 speed
1980 Nishiki Custom Sport 12 speed, (bought it new in 1980 and used it alot back then but not lately)
1980 Ross Grand Tour 10 speed
1985 Raleigh Grand Mesa MTB
1985 Nishiki Pacific Cruiser.
Plus four or five in the process of going together or getting built, plus a dozen or so frames and forks hanging on the wall and a few dozen spare wheels in the rafters and garage attic.
To me, if I look at the '85 Pacific cruiser, which I just completely went through top to bottom, cost around $225 new in 1985 money but even more important, I cannot buy a bike like that brand new today, and anything close would be upwards of $400 or more for a decent shop grade bike. Even then it would likely be just another Chinese made bike.
I have no clue though how to price it today. I realize none are highly 'desireable' models, but they want 'replacement value' on each bike and for the total sum of bikes and parts. What would make 'replacment' of most even harder is that every one of them are taller frame sizes.