Reply to thread

Rat Rod Bikes Bicycle Forum

Help Support Rat Rod Bikes Bicycle Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

[ATTACH=full]23[/ATTACH] Did a power up last Sat. Came up to temp (400 f) in about 5 min. Had it running for about an hour to let the sealers and junk out gas .Will bake som parts soon. Did som line voltage measurements to make sure I wasn't pulling too much on my garage feed all ok.

The outside of the oven didn't get too hot I could hold my hand on most places. The places that the steel studs touch both in and out were hotter but I knew that would happen. I need to learn a little more about the PID controller I'm using too fine tune the temp. Over shoot .


Back
Top