How do I add an extension to bottom of fender support?

Rat Rod Bikes Bicycle Forum

Help Support Rat Rod Bikes Bicycle Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Joined
Mar 28, 2013
Messages
6
Reaction score
0
Rating - 0%
0   0   0
I needed to ask for some input on raising up a fender support.
I am raising the fender in the rear to get some clearance for a slick tire. What can I do to add a 1" extension to raise up the fender? I was thinking of bolting on a metal extension to the frame and then the fender support gets bolted to the metal piece that was added.
Thanks.

http://smg.photobucket.com/user/GMP440/ ... 2527696701
 
What fenders/bike/wheels are you running? I might have a cleaner idea
..

If you're running fat fenders on 24s, you might just grab this:
http://www.niagaracycle.com/categories/wald-324-26-bracket-for-962-26-balloon-fenders

If it's on 20s,just get the 24" version.

$3, factory-loook.

**EDIT- I just saw from your other post that this is a 20" Spyder. Here's a link to the 24" fender strut:
http://www.niagaracycle.com/categories/wald-324-24-bracket-for-962-24-balloon-fenders

even better; just $1.58!!
 
Thank you for the tip. What I am trying to do, is keep the original fender supports and add a filler piece to bolt to the frame where the support mounts to the frame and then the fender support is mounted on top of the filler piece.
I actually did it today. I took two P-clamps, flattened them and drilled the correct hole size. It worked.
The tire I put on is a 20 X 2.125 and it clears but not by much. It's pretty close.
What I think would be better is to find a short rear fender. The fender on the Spyder bike sits lower in the stock position
to fit a 20 X 1.175 tire.
Please keep the suggestions coming. Thanks.
 

Latest posts

Back
Top