Reply to thread

Rat Rod Bikes Bicycle Forum

Help Support Rat Rod Bikes Bicycle Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Just a little more:

almost done with the frame, just have to shorten up that Fork.


[ATTACH=full]34221[/ATTACH]


Yep...too leggy out front without chopping the fork...even without a tire it brings the top bar level,  but we don't want it level...do we?  We want it to cant down.


[ATTACH=full]34222[/ATTACH]


Here's a little weld detail to attach the rear uprights to the little nubs on top of the Univega dropouts.  hammer a little tube so it's rectangular...JAM it into a bigger pipe....tack it and then it sits on the nubs just fine.  They don't point directly upward,  but I can adjust... get on them enough to get a good strong weld.


[ATTACH=full]34223[/ATTACH]


You can barely see in the back there...I prefer to grind down the welds as I go,  then put a thin layer of Bondo on...use your finger to spread it.quick sand it down with some 60 grit..don't use a spatula or putty knife else  you'll be sanding off bondo for days.  So..welding..it's fun yes?...but, cleaning up the joints...UGH...sucks.!

So try to do a little as you go along, if you wait until the end and then have to grind , bondo, sand...it'll drive you nuts..you'll end up wanting to put a fork through your forehead.:43:


franco


Back
Top