Another hub for the UCB Hub Project. As with my other rebuilds, I tore the hub apart and cleaned it up before hand for better pics.
Let's begin with the factory parts diagram
And the UCB Hub Cut Away
Here we go!
Begin by removing the lock nut while holding the square end of the axle on the other side.
Pull the keyed lock washer off.
While holding the brake arm, unscrew the axle from the hub.
Spin the driver counterclockwise to remove it from the hub. Now the brake cylinder and the driving cone will slide out the other side.
Here is what you should be looking at now, aside from my favorite multi-tool.
This is what it should look like inside the hub if it's assembled correctly.
Time to lube 'er up and reassemble. Put the brake cone, brake cylinder, and driving cone together.
Slide the assembly into the Hub shell.
Install the driver assembly into the hub from the other side by spinning it clockwise into the driver cone.
Insert the axle through the driver and screw it into the brake cone.
Tighten the axle up and then back it off 1/8 to 1/4 turn. Install the lock washer and lock nut.
Lets ride!
Let's begin with the factory parts diagram
And the UCB Hub Cut Away
Here we go!
Begin by removing the lock nut while holding the square end of the axle on the other side.
Pull the keyed lock washer off.
While holding the brake arm, unscrew the axle from the hub.
Spin the driver counterclockwise to remove it from the hub. Now the brake cylinder and the driving cone will slide out the other side.
Here is what you should be looking at now, aside from my favorite multi-tool.
This is what it should look like inside the hub if it's assembled correctly.
Time to lube 'er up and reassemble. Put the brake cone, brake cylinder, and driving cone together.
Slide the assembly into the Hub shell.
Install the driver assembly into the hub from the other side by spinning it clockwise into the driver cone.
Insert the axle through the driver and screw it into the brake cone.
Tighten the axle up and then back it off 1/8 to 1/4 turn. Install the lock washer and lock nut.
Lets ride!