I have the unfortunate task of withdrawing from the MBBO competition. While everyone is ok, all three of the residents of my home, my wife, daughter and I were diagnosed with and fought off the Evil Covid. We are ok but I was set too far back in my schedule to complete my build by the...
Got it torn down as much as I need to for painting. Left side rear wheel is getting machined out from 1" to 1 1/8 to fit the axle bearing.
DIY idea for a paint stand.
I did a mockup today and really like the direction this build is going to go. Just imagine this murdered out.
Profile
Front
Rear
With the cup holder.
Cup holder will be replaced with a stick shifter...
I picked up 2 24" rim brake front wheels from Mongoose Alerts to use as rear wheels and 1 26" disc hub from a Mongoose Mack for the front. I need to paint the 24s to get rid of the rim braking polish and get the 1" hubs on the non drive side machined out to 1 1/8" to fit the axle bearings. The...
Sounds like you were way more ambitious than me. Mine will be almost completely bolt on swap out mods. I gathered the stuff before I knew the BO was coming.
Going with 27" apehanger bars above a suspension fork for the disc front brake, 26" front wheel with 2.125" rubber and 24" rear with 3" rubber on Mongoose mag wheels.
The stretch job is going to be cut and weld free.
I'm going to fab up a grip shifter to a stick. Found a couple of good ideas in...