I purchased a set of 65mm rims to try and use on a DYNO GLIDE I had at the time. Turned out they where to big for the rear triangle. So I had this rather expensive set of rims just sitting around taunting me from the corner of my garage. Went to bicycle swap meet one weekend and found a 1980 Schwinn Typhoon frame with a real nice Mag wheel sprocket, frame was slightly bent at the rear. So mind says it's already bent so lets try and bend it more to get those big rims to fit. Bought cheaply and remove fender brace and went to bending with floor jack, once where I wanted it and it looked straight, son welded in new fender brace to strengthen frame back to normal. Used other parts that where sitting on shelves, and a Krylon paint job. Didn't spend to much after the rims. Thanks for taking time to read if you did, here is what I call the TUXEDO TYPHOON