MBBO BAD INFLUENCE!

[Pondo]

Man, I'm glad I checked this now. I just ordered the laid back seat post that's 13/16" with the 7/8" top it needs. This should come in early next week and should allow me to finish in time. Tomorrow I can work on brake, shifter and cabling. Then figure out the pedal situation.

 

[OddJob]

It will look cool with the laid back post too. Accentuate the rake on the fork! Now all you need is for this guy to ride it....

 

[Pondo]

It will look cool with the laid back post too. Accentuate the rake on the fork! Now all you need is for this guy to ride it....

View attachment 283996

Actually, I think I know that guy....

 

[Tintmanpa]

I got to work on the Dragster a bit today. Final assembly is fun, you get to see it all coming together.
View attachment 283754

Rear fender sat too high in the back
View attachment 283755

I added a spacer at the upper mount that dropped it into a better spot
View attachment 283756

Getting the rear wheel set up with the spoke protector and outer trim disc really spiced it up. New chain and it’s getting somewhere. Then I put the drag forks on and it started to get pretty exciting.
View attachment 283757

Stem and bars, looking good
View attachment 283758

I put the brake lever on and wrestled with the grips for a while and, man, this bike is looking so cool!
View attachment 283759View attachment 283760View attachment 283761

That’s as far as I’ll get today. I had hoped to wrap it up this weekend but I still need to install the seat, sissy bar, brake and shifter and then cable it up. Hopefully that will only take a few hours next weekend and I can get some finished pics. I’m really digging this little bike. It’s been a lot of work but a lot of fun too!

She is a beauty for sure

Ok, I just hit a major unanticipated snag. The saddle I have matches the bike’s colors perfectly. In fact I chose these colors to go with the seat. But it’s a short seat and it will make the sissy bar lean forward, like a lot.
View attachment 283971

It should be a fair amount back
View attachment 283970

Any suggestions on how to remedy this? I’m thinking maybe a bracket at the rear or front mount or maybe a leaned back seat post.

I don’t like my seat post either. I’m close to finishing. But will need to cut and weld up the post at a different angle.

 

[Pondo]

She is a beauty for sure


I don’t like my seat post either. I’m close to finishing. But will need to cut and weld up the post at a different angle.

Thanks! It's been a ton of work but the bike is looking great.