More on the progress of BDR 1,
Here are the pieces cut from plate to add the lines for the rat
All pieces welded into place
Final assembly minus the original fins... TOOOO sharp to have on rat even though it would have looked cool. Will most likely go with a shortened rear fender with some mods of course... this should keep the lines flowing better on the bike
All that needs to be done is a little bondo to smooothen it out, then painting will start ....I hope , if I don't come up with any last minute design changes
Here are the pieces cut from plate to add the lines for the rat
All pieces welded into place
Final assembly minus the original fins... TOOOO sharp to have on rat even though it would have looked cool. Will most likely go with a shortened rear fender with some mods of course... this should keep the lines flowing better on the bike
All that needs to be done is a little bondo to smooothen it out, then painting will start ....I hope , if I don't come up with any last minute design changes