I started this build wanting a comfortable full sized chopper that rides well however far I want to go.
Its an old, paint wore off, rusted fork and fender ride. It squeaks if I bounce it and that big balloon tire on back takes the edge off bumps along the way.
I went on a bit of a ride to get this one photo'd up. I know where there's an open gate to one of the washes. I found the target location while out on the mountain bike a couple months back, and figured out a leg or two of the ride back then.
Starting out, there's an tunnel or two to open area that leads to some tubes.
Up the tube,
Inside the grate
At the bottom of the ramp.
On top of the grate
At the top
Mount Charleston in the background.
The entrance tunnel and freeway behind this one.
Out to the Mojave...
Sheep Mtns in the background.
Back out of the grate
Down the wash, rear cog snap ring popped out
Popped it back in and headed up a tunnel I've been wanting to see where it started. Took about 40 min... Opening is the halfway point to my house.
The long road test was a success!!
Last edited: