Re: ELGIN MOTO X - (UPDATED 4-26)
It went like this for me...if you plan to do it it's at your own risk because the Drain-O is some nasty poisonous stuff.
1. Get two buckets of water.
2. Have a few rags handy and some 0000 steel wool.
3. Put on some safety glasses, long pants and shirt, face mask, & thick rubber kitchen gloves
4. In one bucket pour in some of the Drain-O crystals
5. In the other bucket pour in some baking soda with the water.
6. Dip the anodized parts into the Drain-O bucket and pull them out every 20 seconds or so.
7. Parts will start turning black and you can rub off the anodizing with the steel wool.
8. Parts will start to get hot from the chemical process.
9. Once the anodizing is all off, dip the parts into the baking soda bucket to neutralize the process.
10. I then dipped the parts in some soapy water and cleaned them really well.
11. After they dried I polished them on my bench grinder using a RYOBI buffing wheel.
I'm not responsible if you choose to do this and have issues. It's just what I tried and it worked for me.
