getting dents out of chrome fenders.....

[weloveour86FieroSE]

Those dents in the rear fender... How to get them out without cracking or damaging the chrome finish.

Any good tips or tricks?

 

[outskirtscustoms]

Remove the fenders and sometimes you can push them out by hand, if not you can lay it over a bag of sand and gently tap them out with a ball peen hammer.

 

[deorman]

Shot bag, dolly, small head rubber mallet, and ball peen.

 

[Blueboy5000]

Many autobody and chopper motorcycle shops have a device called an English Wheel. That would be ideal and probably not very expensive process.

 

[daniels]

Sometimes, but this will discolor the chrome, you can heat it up really hot with torch and use some dried ice to pop it out. I see that done a lot but again, it'll discolor the chrome.

 

[snarehead123]

i use a small piece of a broomstick the rounded end and just push it in the dent or if needed tap the end of the stick with a rubber mallet.

 

[Walker]

If banging them out doesn't work I have these I'd sell or work out a trade with you.

 

[Stevil]

Geez, Walker...always in it for a sale Good for you.
As for dents it helps if you have the correct matching radius otherwise you'll make a mess
on the outside. Gooood Luck :roll:

 

[Walker]

Yeah Stevil, Dave Ramsay says I need to sell some stuff to get my garage! Had these fenders for almost 2 years and they're just sitting..