Squaring everything up again, with string, long rulers, big squares, little plumb bobs, and tape.
I had to trim things twice before I could line it up well enough to tell anything.
Looks like this 3/8” “sliver” trim will get things square. It might all still need to get a bit shorter.
I believe that I calculated the steel tunnel at the crossmember will need 1/2” trimmed off, But I can’t recall if that was from the long end or the short end of the floor, because it’s not square.
![109AA552-A816-4087-849E-B328871E5A21.jpeg 109AA552-A816-4087-849E-B328871E5A21.jpeg](https://cdn.imagearchive.com/ratrodbikes/data/attach/273/273731-109AA552-A816-4087-849E-B328871E5A21.jpeg)
I had to trim things twice before I could line it up well enough to tell anything.
![16E767B8-FC94-4BFD-A2F0-FCE5594E7158.jpeg 16E767B8-FC94-4BFD-A2F0-FCE5594E7158.jpeg](https://cdn.imagearchive.com/ratrodbikes/data/attach/273/273732-16E767B8-FC94-4BFD-A2F0-FCE5594E7158.jpeg)
Looks like this 3/8” “sliver” trim will get things square. It might all still need to get a bit shorter.
![9664DDB2-BBC3-4985-9B2B-60D72A19BC56.jpeg 9664DDB2-BBC3-4985-9B2B-60D72A19BC56.jpeg](https://cdn.imagearchive.com/ratrodbikes/data/attach/273/273733-9664DDB2-BBC3-4985-9B2B-60D72A19BC56.jpeg)
I believe that I calculated the steel tunnel at the crossmember will need 1/2” trimmed off, But I can’t recall if that was from the long end or the short end of the floor, because it’s not square.