Uncle Dave’s Education Donation

[CRASH]

I know you’re pretty stuck on grips right now (no pun intended?) but bar tape would look really cool on that bar. That bar was made in the early 90s and I remember someone made grips just for that bar that were long enough to cover from the controls to the ends. I never had a set of those and I don’t remember what grips I used. I wonder if the bar diameter is a little undersized.

I’m worried about shock absorption. It’s a school bike, so I want it to be comfortable. I’m not against full tape, but I’d really like to exhaust my grip option first.

 

[Wayne]

So I don’t know what to do. Better adhesive? I guess I just plan to never take the grips off again? What should I use? Epoxy?

Automotive 3M super weather strip adhesive. (Yellow)

The directions for best adhesion, coat the metal and the rubber. Let set for a couple minutes then apply. They are talking about applying a rubber gasket. If you do this, you probably will not get the grip all the way on.

I would add adhesive to closed end of the grip, then adhesive 1/2 the length of the grip up the bar end. Push it on and adjust it quickly. It will take a little time to set because the air cannot get to it.

 

[Pondo]

I’m worried about shock absorption. It’s a school bike, so I want it to be comfortable. I’m not against full tape, but I’d really like to exhaust my grip option first.

They make some pretty cushy comfy bar tapes these days. It might be nice to have the bar covered all the way to the end too. The small bar end plug would need to be figured out.

 

[ingola]

60’s right now. Down to mid 40’s at night.

Definitely not that then here when it gets cold the grips don't grip right because well everything is cold

 

[CRASH]

They make some pretty cushy comfy bar tapes these days. It might be nice to have the bar covered all the way to the end too. The small bar end plug would need to be figured out.

I've done some thinking and I'm just going to go with this option. I'll return the grips on Tuesday and trade up for some cushy bar tape. I already bought some tape, but it's crap because I went cheap. I'll get something cushy, like Cinelli gel cork tape. And yeah, I've got to figure out the bar end problem.

 

[Pondo]

I've done some thinking and I'm just going to go with this option. I'll return the grips on Tuesday and trade up for some cushy bar tape. I already bought some tape, but it's crap because I went cheap. I'll get something cushy, like Cinelli gel cork tape. And yeah, I've got to figure out the bar end problem.

I’ve been wanting to try that Cinelli bar tape, just need the right project to put it on.

I would think you should be able to find a bar end plug solution at the hardware store. Maybe a plastic or stainless cap designed for tubing.

 

[CRASH]

Pads came in

 

[us56456712]

Shifter and brakes came in. While dialing in the shifting I found the chain was too short and the chain line was off.
View attachment 284047

So I added a link to the chain. And I flipped the sprocket from here…
View attachment 284048
To here…
View attachment 284049

Which fixed the chain line
View attachment 284050

So shifting is dialed in. I installed the brakes, they’re set, but the cheap pads are making noise. Pondo recommended Kool Stop salmon pads, so put 4 on order.

Meanwhile… I cleaned up the bar and grips and installed them again… didn’t stick, so I got this…
View attachment 284054

We’ll see how that goes. It’s curing.

I wrapped the bar ends, but they taper down and I can’t find a plug to fit. Anyone have a good suggestion?
View attachment 284055

16 gauge shotgun brass or sparkling wine corks.