Custom machined bar ends/extensions for your bars. Up to 3/4" total extension per side. Can be sized down to fit thick walled aluminum bars by request. $20 for the first pair, $15 for each additional on the same order. 7/8" OD means they are invisible beaneath closed end grips and completely removable if you change you mind later on those rarer bars.
PP [email protected] "Standard" is 1/2" extension per side, as pictured with .720 step for 4130 bars (usually about .740-.745 ID). Unless you specity otherwise, that's what you'll get. Stainless steel bolt is SAE becasue the metric system is for commies
[For safety reasons I don't trust simple friction to hold your weight if you ride hard. More than 3/4" and you're likely to be carrying more pressure from the heel of your hand. Longer models will be a full quill design for strength.]
PP [email protected] "Standard" is 1/2" extension per side, as pictured with .720 step for 4130 bars (usually about .740-.745 ID). Unless you specity otherwise, that's what you'll get. Stainless steel bolt is SAE becasue the metric system is for commies
[For safety reasons I don't trust simple friction to hold your weight if you ride hard. More than 3/4" and you're likely to be carrying more pressure from the heel of your hand. Longer models will be a full quill design for strength.]
Last edited:
