Belt drive in the middle would be cool, good idea!
keep the rubber side down!
keep the rubber side down!
Evolution Flyer
- Thread starter Fv2
- Start date
Help Support Rat Rod Bikes Bicycle Forum:
I'm wondering if the tires might take out the variance in that wobble. And, if it's center belt, the middle rim won't affect the roll anyway. This is def an out of the build box kind of idea!
Fv2
Don't know what I'm doing, gonna do it anyway.
That's what I'm hoping for, as long as it rolls straight enough with tires on I'm happy.
Gonna give it another go today.
Fv2
Don't know what I'm doing, gonna do it anyway.
Tried again, nothing video worthy.
Tires on.
And...
But then it rolls.
And now.
So, do I just put different pressure in each tire?
I think with my roller placement I can run tubes, but if not it'll still lean with solid tires.
Maybe I should try the single tire idea. This is definitely a learning experience, right now I'm trying to figure out how to weld three rims together and keep them level.
Tires on.
And...
But then it rolls.
And now.
So, do I just put different pressure in each tire?
I think with my roller placement I can run tubes, but if not it'll still lean with solid tires.
Maybe I should try the single tire idea. This is definitely a learning experience, right now I'm trying to figure out how to weld three rims together and keep them level.
Def watching this. You might have to do something to get a usable gear ratio if you use the center rim as a pulley. Looks like some good head scratching happening here..
Fv2
Don't know what I'm doing, gonna do it anyway.
It's definitely a learning experience, I have no idea what I'm doing. Just a vision in my head and a drawing on cardboard.Def watching this. You might have to do something to get a usable gear ratio if you use the center rim as a pulley. Looks like some good head scratching happening here..
It's a roller!!
Fv2
Don't know what I'm doing, gonna do it anyway.
And there was alot of WTH to get it there.
That is so cool!
The Renaissance Man
__CERTIFIED DIVER__ (Open Water & Open Dumpster)
Staff member
Moderator
Pro Member
Looking good.
Looks close, is one side of the tire bead not seated fully, causing a flat spot?
keep the rubber side down!
keep the rubber side down!
Fv2
Don't know what I'm doing, gonna do it anyway.
No, the tires are seated. My driveway isn't level and the alley is dipped. It rolls straight on my garage floor.
I think it'll be fine once I get it mounted in the frame and rollers.
Glad to hear it! Too good an idea to not use!
I like how it narrowly missed the trash can, then kept going and just barely got by the telephone pole. You install mind control device in the hub or....er, wait. It's hubless. That's right.
Looks like you are on a roll...
Looks like you are on a roll...
That's awesome! [emoji106] [emoji41]
Even if it sounds like lots of friction...[emoji32]
Gesendet von meinem K00E mit Tapatalk
Even if it sounds like lots of friction...[emoji32]
Gesendet von meinem K00E mit Tapatalk
Fv2
Don't know what I'm doing, gonna do it anyway.
Thanks, I'm working on a plan to get the noise down. In my head I have two options, I'll try the less expensive of the two first. Can't try either til I get the metal sides cut.
