Re: FULL TILT BOOGIE 5/23 update
well, i got a little bit of work done. since im not gonna go the big rubber route this year, i figured why not just stuff a big fender out back instead! :wink: i took a deep monark front fender and rolled it down so that i could incorporate the fender indents into the chainline,so as to only make one cut in the fender. then i shortened the bottom of the fender about 4" to keep it off of the ground. i seem to be running the same crank/sprocket combo as yeshoney,a chrome dogleg with a cwc/wflyer sprocket. im thinking about using the bars shown,but if i do i will add 4" to each side for more pullback. the grips are setting right about where they would be after the extensions.ive got a cool little swiss made "lucifer" headlight that will make a nice teardrop taillight,and a nice old farm implement lever to use for the suicide shifter setup later on. i still have to fab up some lower rocker plates for the forks,and shorten the truss rods. thats all for now from page 3! :lol:
well, i got a little bit of work done. since im not gonna go the big rubber route this year, i figured why not just stuff a big fender out back instead! :wink: i took a deep monark front fender and rolled it down so that i could incorporate the fender indents into the chainline,so as to only make one cut in the fender. then i shortened the bottom of the fender about 4" to keep it off of the ground. i seem to be running the same crank/sprocket combo as yeshoney,a chrome dogleg with a cwc/wflyer sprocket. im thinking about using the bars shown,but if i do i will add 4" to each side for more pullback. the grips are setting right about where they would be after the extensions.ive got a cool little swiss made "lucifer" headlight that will make a nice teardrop taillight,and a nice old farm implement lever to use for the suicide shifter setup later on. i still have to fab up some lower rocker plates for the forks,and shorten the truss rods. thats all for now from page 3! :lol: