I need some help with How to make a stencil

[banana seat Brian]

ok working on my bike and looking to make my own stencles to accent my bike ,going to make a few of the same one that look the same..looking for any videos to help..

 

[banana seat Brian]

found this one to pass on
http://www.youtube.com/watch?v=B9oAl6Mes4M

 

[XC204]

This is a link to a tubing coping program it could be used to draw out simple scalops you enter a tube dia and an angle for an intersecting tube with its dia. it gives a to scale print out that you could cut out of masking film and wrap around your tubes would only do simple scalops .
http://www.metalgeek.com/static/cope.pcgi

 

[JLarkin]

That is a good video. I used frisket or stencil paper. Same basic process: run it through a printer, cutout, put on frame, paint over it and remove.

 

[MikeS]

Check out stencilry. also try stencil punks....Lots of good info on those sites.
http://www.stencilry.org
http://www.stencilpunks.org/

 

[Anonymous]

don't know if this will help but check it out
viewtopic.php?f=3&t=8558