...did it, did it! :mrgreen:
Camera is dead, but I cut down an old Long stem and
made it fit in the metal housing in the steering wheel.
Ran the bolt head out the top, and it secures the wheel to the stem, and
the stem in the fork!
I had to grind a bit off the OD of the stem piece to get it to fit in the wheel. I tapered it some and left it very snug and when I tightened the bolt the stem pc. drew into the metal sleeve in the steering wheel. Its pretty tight,but I may tack weld it alittle...
hmm, a tapered jam fit could work excellently if done precisely. i tink if the taper in the steering wheel and the taper on the tube are the same degreee you could be ok