Schwinn Front Wheel Mounting

[nanac1212]

Had to remove the front wheel on the Town and Country tryke to get it in the Kia Soul. Its the old tryke not the China junk. Anyway was in a hurry so I removed both axle nuts and 2 outer washers, slid fender braces off. When I bumped the wheel down to clear the fork some o5her things fell off. Looks like 2 flange spacer thingys and one of this thing in the pic. Hows does this stuff go back on correctly.

Sent from my GT-P5113 using Tapatalk

 

[KJV]

There is a little hole, that tab gose in on the fork

 

[nanac1212]

What about the 2 flange spacer things?

Sent from my GT-P5113 using Tapatalk

 

[Bendix]

You probably figured it out already, but maybe this will help somebody else:

The doohickey in the photo first goes over the cone. The 2 flanges cover 2 of the wrench flats on the cone, the single flange will then point outward and to the bottom when installed in the fork end. Hub then goes in the fork, stepped washer goes on next as a spacer for good axle/fork end fit. Then fender strut, plain washer, axle nut. ;-)