i still havent finished my tank for my boardtrack racer, but i decide i wouldn't mind taking it out for a test drive.
broke out the 80cc engine and it occured to me that these broken english instructions don't make much sence.
i'm hoping one of you can help translate.
problem #1 circuit indications (which i assume means curcuit instructions)
"correctly install the electronic ignition set, the blue wire or the red wire of the ignition, the blue wire of the connecting coils"
so i connected the blue to blue, black to black and that leaves me a white wire (motor) and a yellow and black wire (throttle) none of the wires are mentioned again in the instructions. what goes where?
problem 2 ajustment of clutch
"at the ends of the handle of the clutch,please ensure keep a certain free space,generally 2-3mm. only proper space able to ensure the timely decoupling of the clutch and free of slipery. in the course of ajustment,loosen the handle of the clutch,turn the hollow center screws,turn outside for decrease space,turn inside for increased space. after ajustment, tighten the nuts to avoid loose. if slipery in case of proper space,dimantle the cover of the clutch to check if cover sleeve of the clutch is loose, and tighten if necessary. "
uuuuum, yeah. i'm confused. what i would really like to know is this, how do i properly connect the clutch cable.
i'm assuming i have the parts in the right place.
but i was hoping somebody could give me a ball park idea of where to set the stop on the cable.
how far does that arm have to move, and where should it be when its in its relaxed position.
any info would be greatly appreciated, and pic's are always welcome.
thx guys, all this broken english indications are makin me feel stupid.
broke out the 80cc engine and it occured to me that these broken english instructions don't make much sence.
i'm hoping one of you can help translate.
problem #1 circuit indications (which i assume means curcuit instructions)
"correctly install the electronic ignition set, the blue wire or the red wire of the ignition, the blue wire of the connecting coils"
so i connected the blue to blue, black to black and that leaves me a white wire (motor) and a yellow and black wire (throttle) none of the wires are mentioned again in the instructions. what goes where?
problem 2 ajustment of clutch
"at the ends of the handle of the clutch,please ensure keep a certain free space,generally 2-3mm. only proper space able to ensure the timely decoupling of the clutch and free of slipery. in the course of ajustment,loosen the handle of the clutch,turn the hollow center screws,turn outside for decrease space,turn inside for increased space. after ajustment, tighten the nuts to avoid loose. if slipery in case of proper space,dimantle the cover of the clutch to check if cover sleeve of the clutch is loose, and tighten if necessary. "
uuuuum, yeah. i'm confused. what i would really like to know is this, how do i properly connect the clutch cable.
i'm assuming i have the parts in the right place.
but i was hoping somebody could give me a ball park idea of where to set the stop on the cable.
how far does that arm have to move, and where should it be when its in its relaxed position.
any info would be greatly appreciated, and pic's are always welcome.
thx guys, all this broken english indications are makin me feel stupid.