Re: "Sour Apple"
deorman said:
It surprises me that you did all that, and yet took it to a shop for tuning. :?
This is my first time working on a bike and i just wanted to have the bike looked over to make sure i put it together right
chimichanga said:
how long did it take to mask the seat?
about 30 min
stretch said:
and how DID you do that? ive been thinking about it.. and i cant figure it out! :|
So I decided to do a demo of how to make the checkers on the seat. here is how to mask it:
1.start with your object. for this demo I just drew a seat pan outline on a piece of paper
2: Then I took a roll of 3/4 inch 3m UV Tape
3. Next take and run the tape with wise across the seat make sure the first tape is run straight it will be your reference tape(if it is crooked you will see it later). Then run tape right along beside the first tape leaving no gaps or overlap.
cover your whole seat this way
4. Now over top of your tape you just put down run a single piece down the centre of the tape lengthwise. Make sure it is straight so that your squares are square and not diamonds. This is the second reference point.
then like in the second part of step 3 cover the whole seat this way
5.Now remove every other piece of tape that you just put down
6. Take an exacto knife with a new blade and cut along both sides of the length wise tapes. be care full not to cut into the seat it self just use enough pressure on the knife to cut the tape only
7. Remove the final length wise tapes slowly so that you do not remove the width wise ones
8. Now pull out every other square
when you are done you should have this:
now you can paint the squares and un-mask after. the checkers look crooked in the pictue because the paper is warped.
note: when you start and if you have a black seat pan and want black and white checkers you can save your self a step and time. Do this by scuffing the bottom with the less abrasive scotch brite sanding pad just till the shine is off but keep it black. then mask the checkers off, paint the white, then peal the masking off and clear coat it.
I hope this makes sence