Nice Flathead motor for the bee.
Smart thinkin!
Smart thinkin!
Sticking with the diamond grips. The color and pattern are too perfect.
View attachment 273537
@MattiThundrrr Here's your duel
View attachment 273538
Going to tighten the screens all the way down. The thread pitch is way different, though the diameter matches, so I'll have to crank 'em down.
View attachment 273539
Wu Tang badge ain't nothing to mess with!It can be used as a bottle opener
Was planning on using earth magnets to attach the 'W' to the top plate...but the stainless steel isn't magnetic
View attachment 273532
I considered mounting these shelf clips to hold it, but the positioning would be off.
View attachment 273533
View attachment 273536
Experimented with a suction cup, but not sure how long it would hold on a ride.
View attachment 273534
So I put rubber washers top and bottom and ran the bolt through. Leaving this as inspiration, for now, but will fabricate a low profile hanger, in similar fashion to a plate hanger without springs.
View attachment 273535
It can be used as a bottle opener, so I want to be able to detach and re-attach it with some ease.
Enter your email address to join: